-
Looking to take your short path system to the next level? A diffusion pump will provide deeper vacuum and lower temps resulting in higher efficiency and increased speed. Package comes with an Edwards 30 roughing pump, the adapters to connect the diffusion, chiller to control temperatures and custom built and tuned SVG-3 setup with UHVP Sensor.
- High rate Diffusion Pump
- Adapters to fit
- 3/4 HP Chiller
- E2M30 kit
- SVG-3 (3 zone gauge)
- UHVP Sensor
-
$3,325.00
Factory rebuilt We get our rebuilt pumps from a Thermo Fisher Testing Center. All are chemically cleaned, and restored to brand new condition with 99-100% test motors with factory Edwards full parts kit. Everything replaced and serviced regardless of condition by the nations leading Edwards warranty center. Comes with a warranty, all pumps are tested in house to manufactures ratings prior to shipping.Pump comes with:- Edwards 30 pump 220v
- 5 gallons I 19 Standard oil
- New emf20 filter
-
$14,999.99
New GVD80 + New EMF100 Filter + 5 gal oil Edwards GVD80 series two stage oil sealed rotary vane vacuum pumps are renowned for their high ultimate vacuum, rapid pumping speeds, quiet operation and ability to handle water vapor. These direct drive rotary vane pumps are inherently compact and vibration free, and with their finger-proof fan and coupling housings they offer excellent operator protection. We also carry GVD28s for smaller applications. We get our pumps from a thermo fisher service and testing centers. Some are brand new never used. Some are used for 30 days to 30 hours max. All are chemically cleaned, and restored to brand new condition with 99-100% test motors with factory Edwards full parts kit. Everything replaced. Comes with a 6 months unconditional warranty other than direct misuse. This beast is ready to serve you.Pump comes with :- GVD80 pump 3-phase
- 5 gallons I 19 Standard
- New EMF100 filter
- Comes standard with KF40 connections
-
$8,275.00
New ACP15 multi-stage pump
- The New ACP15 multi-stage pump meets the requirements of applications where clean and dry vacuum is needed.
- The frictionless pumping module is optimized to operate without internal lubricant and provides outstanding oil-free vacuum with no hydrocarbon vapor back streaming. Without any seals between rotor and stator no particles are generated.
- The absence of wearing parts inside the pumping module allows for unsurpassed long-term stability and high reliability in even the most demanding applications.
- The frequency converter driven motor provides constant rotational speed, thus stable pumping speed and consistent ultimate pressure are achieved all over the world.
- Our ACP pumps require overhaul only every 22,000 hours of operation for the ACP 28/40 and 20,000 hours of operation for the ACP 15 resulting in low cost of ownership.
- High flow gas ballast ports and drainable silencers allow the ACP to pump high amounts of condensable vapors (up to 1,000 g/h of pure water vapor).
-
$10,515.00
New ACP28 multi-stage pump
- The New ACP28 multi-stage pump meets the requirements of applications where clean and dry vacuum is needed.
- The frictionless pumping module is optimized to operate without internal lubricant and provides outstanding oil-free vacuum with no hydrocarbon vapor back streaming. Without any seals between rotor and stator no particles are generated.
- The absence of wearing parts inside the pumping module allows for unsurpassed long-term stability and high reliability in even the most demanding applications.
- The frequency converter driven motor provides constant rotational speed, thus stable pumping speed and consistent ultimate pressure are achieved all over the world.
- Our ACP pumps require overhaul only every 22,000 hours of operation for the ACP 28/40 and 20,000 hours of operation for the ACP 15 resulting in low cost of ownership.
- High flow gas ballast ports and drainable silencers allow the ACP to pump high amounts of condensable vapors (up to 1,000 g/h of pure water vapor).
-
$12,525.00
New ACP40 multi-stage pump
- The New ACP40 multi-stage pump meets the requirements of applications where clean and dry vacuum is needed.
- The frictionless pumping module is optimized to operate without internal lubricant and provides outstanding oil-free vacuum with no hydrocarbon vapor back streaming. Without any seals between rotor and stator no particles are generated.
- The absence of wearing parts inside the pumping module allows for unsurpassed long-term stability and high reliability in even the most demanding applications.
- The frequency converter driven motor provides constant rotational speed, thus stable pumping speed and consistent ultimate pressure are achieved all over the world.
- Our ACP pumps require overhaul only every 22,000 hours of operation for the ACP 28/40 and 20,000 hours of operation for the ACP 15 resulting in low cost of ownership.
- High flow gas ballast ports and drainable silencers allow the ACP to pump high amounts of condensable vapors (up to 1,000 g/h of pure water vapor).
-
$4,685.00
Atlas Copco GVD28 1 Phase, 110-120/200-230V, 50/60Hz. Pump oil and EMF20 with accessories not included.- Type of product: Vane Pump
- Condition: New
- Inlet: KF25
- Exhaust: Hose Nipple
- Motor: 1 Phase, 110-120/200-230V, 50/60Hz
- Oil: Hydrocarbon
- Pumping speed: 23.3 CFM (60 Hz)
- Ultimate vacuum: 7.7 x 10-4 Torr (without gas ballast)
- Weight: 97 lbs
-
$3,600.00 $3,000.00
One-stage diaphragm pumps are an excellent solution for continuous, oil-free pumping of gases and vapors at low vacuum requirement. In contrast to waterjet pumps they do not consume water and therefore do not produce any contaminated waste water in daily use. Typical applications are vacuum ovens, filtrations and multi-port manifolds for medium throughput, as well as pumping of gases and oil-free evacuation in general. The one-stage construction provides the advantageous combination of high pumping speed and low ultimate vacuum down to 70 mbar. Diaphragm Pump 2 Head MZ2NT To purchase, please contact Summit Research at 8312262948 or by eMail. Items ship 1-3 days after orders have been processed unless otherwise specified. Price does not include shipping and will be included in your final estimate before processing. -
$248.00
I 19 Standard Vacuum Pump Fluid. 5 Gallons (18.927 Liters) Hydrocarbon fluid for mechanical vacuum pumps used in non-corrosive applications. This premium grade oil produces lower vapor pressures, reduced backstreaming, and has longer fluid life. sds To purchase, please contact Summit Research at 831-226-2948 or by eMail. Items ship 1-3 days after orders have been processed unless otherwise specified. Price does not include shipping and will be included in your final estimate before processing.